Filter
Top Products
E
Installation Instructions
6
9 OVEN INSTALLATION
THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT
REFERRING TO THE MOUNTING INSTRUCTIONS FOUND ON
WALL AND TOP CABINET TEMPLATES.
THE NEXT STEP IS TO READ AND FOLLOW MOUNTING
INFORMATION ON WALL AND TOP CABINET TEMPLATES.
THIS OVEN MUST BE ATTACHED TO AT LEAST ONE WALL
STUD. SEE WALL CONSTRUCTION ON PAGE 1.
WHEN DONE WITH TEMPLATES, PROCEED TO MOUNTING
SCALE PLATE SECTION.
MOUNTING SCALE PLATE SPACERS
Attach 2 Scale Plates with tape (not included). See Figure 16 and
WALL TEMPLATE for locations.
Scale Plates
Mounting Plate
Figure 16
MOUNTING PLATE
1. Separate 4 Toggle Bolts, packed in the INSTALLATION
HARDWARE, from the Toggle Nuts.
2. Match 5/8" holes (not in studs), drilled through WALL
TEMPLATE into wall to corresponding holes on Mounting
Plate.
3. Insert Toggle Bolts into matched openings on Mounting Plate.
Put Toggle Nuts on Toggle Bolts. See Figure 17.
4. Position the Mounting Plate with the Toggle Bolts attached at
the wall location and insert Toggle Nuts and Bolts through the
holes in the wall with the Toggle Nuts closed. Figure 18. Use
Wood Screws to attach the Mounting Plate to studs.
NOTE: Before insertion, be sure you leave a space more than
the thickness of the wall between the Mounting Plate and
the end of each of the Toggle Nuts (in the closed position).
If you do not leave enough space, the Toggle Nut will not be
able to open on the other side of the wall. Also, once a Toggle
Nut opens, it cannot be withdrawn from the hole; therefore
make sure all of the Toggles are in the correct position before
insertion.
5. Align the Mounting Plate carefully and hold in position while
tightening Toggle Bolts. Pull Toggle Bolt toward you and turn
clockwise to tighten. Figure 19.
6. Remove scale plates.
Figure 17
Toggle Bolt
Toggle Nut
Mounting Plate
Space more
than wall
thickness
Wall
Figure 18 Figure 19