Filter
Top Products
Electrical Connections
The disposer is designed to be connected to a 240V
50Hz electricity supply.
All electrical installation work should be carried out
by a trained electrician or competent person.
THIS APPLIANCE MUST BE EARTHED.
The manufacturer disclaims any responsibility
should these safety instructions not be carried out.
The disposer is supplied with a mains lead which has
the following coloured wires:
Green and Yellow –Earth
Blue –Neutral
Brown –Live
When fitting a plug or connecting to a flex
connection unit or fused spur, the wires of your
mains lead may not correspond with the markings
identifying the terminals in your flex connector or
fused spur, proceed as follows:
Connect the green and yellow (earth) wire to the
terminal which is marked with the letter ‘E’ or the
earth symbol, or coloured green or green and yellow.
Connect the blue (neutral) wire to the terminal
which is marked with the letter ‘N’ or coloured
black.
Connect the brown (live) wire to the terminal which
is marked with the letter ‘L’ or coloured red.
It is recommended to connect the disposer to a flex
connection unit. This connection point should then
be controlled by a 13 amp switched fused unit
positioned above kitchen worktop level which is
easily accessible.
The 13 amp fuse should conform to BS1362 and be
ASTA or BS1 approved.
13 AMP FUSE
BS 1362
6