Filter
Top Products
While defrosting
DRAIN CAP
DRAIN BULB
6
HOW TO DEFROST
Freezer compartment
The freezer compartment should be kept free of the frost for good freezing
effects and economical operation at low power consumption. Frost should
not be allowed to grow thicker than 5 mm. (0.2 inches).
Scrape frost off the freezer compartment walls with the scraper supplied
with your refrigerator. This can be done without stopping operation.
Refrigerator compartment
The cooling (evaporator) unit in the refrigerator compartment is automatically
defrosted whenever the compressor motor stops running. No manual control
is required. Frost may grow thick temporarily if the room temperature is high
or the door is opened frequently. Under normal condition, however, it will
disappear after a period of operation.
After a long period operation, frost in the freezer compartment may
become too hard to be removed with a scraper. If it does, set the
temperature control dial to “0” or “OFF” leave the freezer compartment
door open for several minutes, and wipe the freezer compartment wall
clean of frost with a hot towel. After that, wipe the walls dry and reset
the control dial.
2.
1.
While defrosting, pull the DRAIN CAP
out from the DRAIN BULB as illustrated.
The DRAIN CAP is inside the freezer
compartment.
When defrosting is completed, fit the
DRAIN CAP back to the place.
Defrosting (Only Model WRM3500_A-R)