Elitair ZN-36 Ventilation Hood User Manual


 
- 9 -
USE
• If the apparatus is equipped with the following controls (fig.7A):
A = OFF
B = SPEED I
C = SPEED II
D = SPEED III
E = LIGHT
• If the apparatus is equipped with the following controls (fig.7B):
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III
F = AUTOMATIC STOP TIMER - 15 minutes
If your appliance does have the INTENSIVE speed function, press key E for two seconds
and it will be activated for 10 minutes after which it will return to the previously set speed.
When the function is active the LED flashes. To interrupt it before the 10 minutes have
expired press key E again.
By pressing key F for two seconds (with the hood switched off) the “clean air” function is
activated. This function switches the appliance on for ten minutes every hour at the first
speed. As soon as this function is activated the motor starts up at the first speed for ten
minutes, During this time key F and key C must flash at the same time.
After ten minutes the motor switches off and the LED of key F remains switched on with a
fixed light until the motor starts up again at the first speed after fifty minutes and keys F
and C start to flash again for ten minutes and so on.
By pressing any key for the exclusion of the hood light the hood will return immediately to
its normal functioning (e.g. if key D is pressed the “clean air” function is deactivated and
the motor moves to the 2nd speed straight away. By pressing key B the function is deac-
tivated).
• The “automatic stop timer” delays stopping of the hood, which will continue functioning for
15 minutes at the operating speed set at the time this function is activated.
• Active carbon/grease filter saturation:
- When button A flashes at a frequency of 2 seconds, the grease filters must be
cleaned.
- When button A flashes at a frequency of 0.5 seconds, the carbon filters must be
replaced.
After the clean filter has been replaced, the electronic memory must be reset by
pressing button A for approximately 5 seconds, until the light on the button stops
flashing.