Equator WB 818 Dishwasher User Manual


 
start or run.
Motor (bad bearings or locked
rotor).
Replace motor.
Motor trips out on in
terminal thermal overload
protector.
Start relay not dropping out.
Improper voltage.
Seal faces binding.
Motor shaft binding.
Motor windings shorted.
Glass or foreign items in pump.
Replace start relay.
Check voltage.
Repair or replace.
Repair or replace.
Repair motor.
Clean and clear area.
Repeated dishwasher cycles
Circuit board (contacts open or
burnt)
Motor (inoperative, check
resistances).
Replace circuit board.
Replace timer.
Dishwasher does not
advance automatically.
Damaged circuit board.
Check circuit for power ,check if
the wire misconnected.
Have wire cut off
Replace circuit board.
Reconnected wire and circuit
board .
Repair.
Dishwasher will not fill with
water.
Water supply turns off.
Defective inlet valve.
Check valve screen for
obstructions.
Defective float switch.
Damaged circuit board.
Wiring (broken or burnt).
Turn water supply on.
Replace inlet valve.
Disassemble and clean screen.
Replace switch.
Replace circuit board .
Repair or replace.
Incomplete water fill.
Low water pressure.
Clogged water inlet valve screen.
Heavy water supply usage
elsewhere in home.
Kinked or restricted fill hose, water
inlet valve to fill tunnel.
Minimum water pressure of
15P.S.I
Clean water inlet valve screen.
Use dishwasher when water
usage is at a minimum.
Correct as needed.
Too much water fill.
Water inlet fill valve defective.
Damaged circuit board (open or
burnt).
Float arm binding or out of
adjustment.
Replace water inlet fill valve.
Replace circuit board.
Repair, adjust or replace.
Dishwasher will not pump
out.
Drain pump is restricted.
Damaged impeller.
Wiring or terminal (contacts open
or burnt).
Clear restrictions.
Replace drain pump.
Replace circuit board.
Water siphons out.
Drain hose loop to low.
Drain line connected to a floor
drain not vented.
Move to proper height.
Install vent air gap at counter
top.
Water leaks.
Spray arm not rotating or split.
Check for proper rotation or
replace spray arm.
11