Equator WB 818 Dishwasher User Manual


 
Defective seal on plunger.
Over filling container.
Replace plunger.
Follow instructions in owner’s
manual.
Noisy pump assembly.
Impellers not properly shimmed or
rubbing.
Pump parts not properly installed.
Debris in bottom of tub sump area.
Defective motor bearings.
Use shim gauge furnished in
impeller and seal kit, when seals
are properly shimmed the
impellers will be in correct
operating position.
Inspect and correct.
Clean out sump area.
Replace motor.
Dishwasher continues to fill
or continues to fill even
though in case of there is no
voltage to fill valve.
Something (dirt or foreign
material) under diaphragm in water
inlet valve.
Defective water inlet fill valve.
Clean water inlet valve or
replace.
Replace water inlet valve.
Detergent left in dispenser.
Detergent cup held or blocked by
large dishes.
Dispenser wet when detergent
was added.
On proper loading dishes.
Instructs customer/user.
Softener leaking
Softener broken.
Softener nut loosen.
Replace softener.
Screw down softener cap.
Leaking form air inlet.
Air inlet nut loose.
Air inlet install up side down.
Screw down air inlet nut.
Reinstall air inlet properly.
Window Display “E1”
Inlet Valve Damaged.
Inlet Valve Disconnected.
Replace Inlet Valve.
Reconnected Line.
Window Display “E2”
Pressure Switch Damaged. Replace Pressure Switch.
Window Display “E3”
Heating Element (open).
Power Supply To heating Element
Cutting.
Replace.
Reconnect Line.
Window Display “E4”
Float Switch Act. Take Remove The Rubber Cap
Let Water Pour Out.
Window Display “E5”
Thermostat Sensor Damaged. Replace sensor(See figure8).
13