Filter
Top Products
III- Installing the remote control outside the cellar
The remote control can also be placed outside the cellar.
In this case, it is essential to connect a sensor (supplied with the appliance) to the remote control before installing it.
a- Connecting the sensor to the remote control
- On the back of the remote control, push the 2 batteries downwards using a screwdriver (see diagram below).
- Remove the central knob, unscrew the screw with a small screwdriver and open the unit (see diagram below)
On the back, connect the sensor’s 2 wires (blue and red) to the circuit connector using a small at screwdriver (see diagram below).
You can connect either the blue wire or the red wire to the circuit connector.
Pass the wires through the recess on the top of the unit.
- Close the unit, ensuring that the wires pass through the recess and are not jammed
- Rescrew and replace the central knob
9 - INSTALLING THE REMOTE CONTROL
Battery CR2430
16