Filter
Top Products
- Programming the remote control
Where placing the remote control outside the cellar, having connected the external sensor, it is essential to reprogramme the unit
- To turn on the remote control, press and hold down the key for about 8 seconds until the indicator goes o.
- First press and continuously hold down the key, at the same time press and continuously hold down the key for several seconds until three
lines appear.The model number is then displayed and ashes. .
- Press .
- The screen appears indicating IN (IN= internal installation). Press the key to change to OUT external mode.
- The display appears indicating OUT (OUT= external installation). Press to conrm.
- The pictogram appears. Press .
- The screen appears. Press .
- The pictogram appears. Press .
- .appears. Press .
- The pictogram appears. Press .
- The screen appears, then .
If you wish to reprogramme the remote control for
an internal sensor,disconnect the wired sensor and reprogramme the remote control in internal mode
(IN) by repeating the rst two steps described in the paragraph above (see 5-III-b p.11):
The 2nd screen displays indicating OUT (OUT= external installation). Press the key to change to IN internal mode. Press to
conrm.
Then repeat the same steps, as indicated in the above paragraph (see 5-III-b).
c- Fitting
- Fit the remote control and sensor using the screws and pegs supplied (see diagram on page 9, chapter II).
- Place the sensor inside the cellar.
- Place the sensor as close as possible to the bottles
N.B.: the sensor has a range of 3 metres.
9 - INSTALLING THE REMOTE CONTROL
17