Eurotech Appliances EDW194E Dishwasher User Manual


 
14
BUILDING A CUSTOM WOOD DOOR PANEL FOR MODEL EDW194E
If you prefer, you can build a custom wood door panel for this model to match the cabinets.
CUSTOM WOOD PANEL DIMENSIONS
Width: 23-3/8 (595 mm)
Height: 28-1/4 min. to 30-1/16 max.
(718 mm764 mm)
(Measured from the top of the panel to the lower edge of the kitchen cabinet.)
Thickness: 1/4 (6 mm) minimum to 3/4 (19 mm) maximum
Weight: Up to 22 lb.
NOTE: Screws for mounting custom wood panels less than 3/4 are not supplied with the unit.
MOISTURE BARRIER
Among the materials supplied with your unit are two strips of moisture resistant material (moisture barriers).
One of these is intended to be affixed along the bottom edge of the back of the wood panel to prevent
possible moisture damage. You should affix the moisture barrier to the panel before you attach the panel to
the dishwasher door.
CUSTOM WOOD PANELS THAT EXTEND TO THE CABINET TOP (30-1/16)
With this installation, the custom panel extends 1-13/16 inches above the dishwasher
control panel, as illustrated at right.
This installation also leaves a 2 gap between the top of the dishwasher and the
cabinet. We recommend that you install the 2 fill strip that comes with the unit
between the upper edge of the dishwasher and the counter to hide the top of the
dishwasher and further reduce water noise.
NOTE: You will also need to build a custom wood toe kick to match the wood door panel.
Panel extends from toe kick to cabinet top
toe kick
30-1/16"
764 mm
23-3/8"
595 mm
2-inch fill strip
toe kick