Eurotech Appliances EDW194E Dishwasher User Manual


 
9
ENGLISH
TECHNICAL DATA
Water pressure 18-176 psi
Power 110120 v, 60 Hz
Heating element 1200 w
Max loading 1450 w
EASY CONNECTION
Your Eurotech comes with everything you need for an easy, problem-free installation:
n PEX tubing with 3/8 compression fittingThis tubing has a 50-year spec life. It fits American
dishwasher water supply valves.
n Drain hoseCorrugated drain hose and holder to form a high loop.
n Electrical cord and plug110-120 volts, 15 amp cord supplied with unit.
WARNING! Do not use an extension cord for this appliance.
WATER SUPPLY
WARNING! Plumbing connections must comply with applicable sanitary, safety and
plumbing codes in your area.
The dishwasher comes with a 5-foot PEX water supply line that has a 3/8" NPT female connection. Be sure
to insert the black rubber washer (enclosed in the hardware package) into the PEX hose connection
before you attach it to the water supply.
The electrical and water supplies should come through the right side of the machine, a maximum of 2 (50
mm) from the back wall and 6-1/4 to 8-1/4 (159210 mm) from the floor, depending on the underneath
cabinet height.
For service convenience, a shut-off valve (not supplied) should be installed in the water supply line in an
easily accessible location, such as, beneath the sink.
It is important that the water supply line and the shut-off valve have a sufficient flow volume. At least 3
gallons (12 liters) per minute must be able to pass through the line. The water pressure should be 18-176
psi.
WARNING! In order to prevent heat damage to the inlet valve, all solder connections
must be made before the water line is connected to the dishwasher.
NOTE: Be sure to run the PEX water supply
line, drain line, and power supply
cord through the hole to sink
compartment before moving the
dishwasher into position.
(1) Water supply
(2) Water supply valve (not supplied)