Filter
Top Products
Version 7/07 - Page 5
Inca Pro 38 can be used with
custom hoods 40” wide and up.
Choose either a custom liner or our
ProLiner designed for 42” and 48”
wide installations. Liners create a
perfectly-sealed, non-combustible
finish for the underside of your
custom/wood hood.
The ProLiners are made up of two
sections: a larger, rear section
(pre-cut out for insertion of the
Inca Pro 38) and a front section for
a total adjustable depth between
21" and 25".
Consider the shape, size, and
weight of the Inca Pro 38 and Liner
to determine the configuration
of the custom/wood hood. See
RANGEHOOD DIMENSIONS AND
LINER DIMENSIONS on Page 4.
FOR INSTALLATIONS WITH LINERS
CUSTOM/WOOD
HOOD
PRO LINER
WARNING
!
When building a custom hood,
always follow all applicable
codes and standards.
TOOLS NEEDED FOR INSTALLATION
• Saber Saw or Jig Saw
• Drill
• 1 1/4" Wood Drill Bit
• Pliers
• Phillips Screwdriver
• Wire Stripper or Utility Knife
• Metal Snips
• Measuring Tape or Ruler
• Level
• Pencil
• Caulking Gun
• Duct Tape
PARTS SUPPLIED FOR INSTALLATION
• 2 Backdraft Dampers
• 1 Literature Package
PARTS NEEDED FOR INSTALLATION
• 2 Conduit Connectors
• Power Supply Cable
• Screws to Reinforce Atttachment
• Scews for Field Wiring Box
• 1 or 2 Wall or Roof Caps
• All Metal Ductwork
OPTIONAL ACCESSORIES AVAILABLE
• Duct Transition Kit
optional kit, transitions two 6" round openings to one 10" round
opening
part # 620000087
• *Charcoal Filters (Order 2 Kits)
* it is highly recommended that professional style cooking always
be vented to the outside; for recirculating installations only, some
ductwork is required to exhaust the unit out of the cabinet.
part # 6093034
YOU MUST ORDER TWO OF PART #6093034 (ONE KIT FOR
EACH OF THE TWO INCA PRO MOTORS)
• Liners
Create a perfectly-sealed, non-combustible perimeter around the
Inca Pro 38. Depth adjustable from 21” - 25”.
ProLiner 42 Stainless - part # 620000302
ProLiner 48 Stainless - part # 620000303
INCA PRO 38
1. The custom/wood hood must have a sturdy base (3/4" plywood recommended) to accomodate the cut-out for the Inca Pro 38. The
base must be recessed to accomodate the height of the Liner (see LINER DIMENSIONS on Page 4). The Liner attaches to the bottom
of the base using screws appropriate for the size and material of your custom/wood hood. The Inca Pro 38 inserts into the cut-out in the
Liner and base.
2. Position the rear section of the Liner so that it abuts the back edge of your custom/wood hood. Using a pen, trace the outline of the
pre-cut out. Remove the Liner and proceed to MAKE YOUR CUT-OUTS on Page 6. Install both sections of the Liner and proceed to
INSTALL THE RANGEHOOD on Page 7.