Filter
Top Products
6
• Do not install the refrigerator outdoors or
where it can be exposed to rain. Install
your appliance in a dry room and avoid
high humidity areas such as basements
and garages.
• Install the refrigerator away from heat
sources and protect it from direct
sunlight in order to conserve energy.
Leveling the Appliance
• For suffi cient leveling and air circulation
in the lower rear section of the appliance,
the bottom feet may need to be adjusted.
You can adjust them manually or by
using a suitable spanner.
• The unit will not function properly if tilted
more than 25/64” (10 mm). Please level
the unit as fl at as possible.
Installing the Door Handles
For transportation convenience, the door
handles are separately packaged in a plastic
bag. To install the handles, follow the steps
below.
1. Remove screw covers on the left side of
the door and put them into the plastic
bag.
2. Place the handle on the left side of
the door, keeping the screw holes in
the handle and the door in line, as the
picture shows.
3. Attach the handle with the special
screws provided in the bag and then
install the handle covers.
Reversing the Door Hinge
The side which the door opens on can be
changed from the right side (as supplied)
to the left side. Disconnect the refrigerator
from the power outlet and remove products
stored on the inside of the door.
WARNING: This procedure should only be
carried out by qualifi ed individuals. Certain
aspects of this procedure may require two
people.
Tools you will need:
Note: When laying the refrigerator on its
back to gain access to the base, you should
rest it on a soft foam pad or similar material to
avoid damaging the back of the refrigerator.
To reverse the door, the following steps are
recommended.
1. With the refrigerator upright, open the
upper door to take out all door racks (to
avoid rack damage) and then close the
door.
≤25/64” (10mm)
8mm socket wrench
8mm wrench
Flathead screwdriver
Phillips screwdriver