Filter
Top Products
19
Rinse aid
We highly recommend the regular use of liquid rinse aid to give the best drying results. Rinse
aid gives a streak-free, sparkling clean look to glass and chinaware. In addition it prevents metal
from tarnishing. The rinse aid dispenser is located on the inside panel of the door.
Filling the rinse aid dispenser
1
Open the dispenser by turning the cap in an anticlockwise
direction.
2
Pour the rinse aid into the dispenser, making sure not to
overfill.
Take care not to spill rinse aid into the dishwasher. Any spills
must be wiped up to prevent excess foaming. Failure to wipe
up rinse aid spills may result in a service call, which will not
be covered by warranty.
3
Fit the cap back in the original position.
How much rinse aid to use
The dose regulator may need to be adjusted to suit your
water conditions. Regulate the amount of rinse aid by turning
the dose regulator, using a screwdriver. The dose regulator is
located underneath the rinse aid cap.
There are six dosage settings; the lowest setting is ‘1’ and
the highest setting is ‘6’. The normal dosage is setting ‘1’. If
there is excessive foaming at the end of the wash, reduce the
setting. If dishes are wet or streaky after drying, increase the
setting.
Rinse Aid indicator light
When the rinse aid level becomes low, the Rinse Aid indicator
will light up to remind you to refill the rinse aid. The Rinse Aid
indicator light can be found on the detergent dispenser cover
for all models, and on the exterior control panel
for models DW60CDW2 and DW60CDX2.
Fig. 7 Opening the rinse aid dispenser
Fig. 8 Adjusting the dose regulator
Fig. 9 Rinse Aid indicator light