Filter
Top Products
5
Installation instructions
Plumbing
Drainage
The recommended method of installation is shown in diagrams 1,2 and 3. The diagrams are
designed to eliminate problems that occur with combined sink – dishwasher waste systems.
The standpipe must have a minimum diameter of 38 mm and stand 750mm above the floor. A
drain hose support is provided to hold the drain hose in place in the standpipe (See diagrams 1
and 2). It is not recommended that the drain hose or drain pipe be connected directly to a waste
disposal unit (see diagram 2).
When connecting the drain hose to a sink trap with a drain hose spigot, it is important that the
drain hose is supported to the height of the bench (see diagram 3). Ensure the drain spigot has
a minimum hole size of 15 mm and that it has been drilled out.
Diagram 1: Dishwasher
Diagram 2: Dishwasher & waste disposal unit
Diagram 3: Dishwasher using sink trap with dishwasher drain hose spigot
Standpipe Ø38 mm
750 mm MIN above oor
*
note:
Connection of drain hose
direct to the waste disposal
unit is NOT recommended.
Hose supplied
Switched power socket
Waste
Water
200 mm MIN
Vent
Waste disposal
unit
Switched power socket
Hose supplied
200 mm MIN
Water
Waste
*
Switched power socket
Hose supplied
Standpipe Ø38 mm
750 mm MIN above oor
*
*
Waste
Waste
200 mm MIN
Water
Waste