Filter
Top Products
11
Installation instructions
Fastening the cooktop to the bench (CE604 models)
1
Turn the cooktop upside down and place it on a soft surface.
2
Spread the seal around the edges of the cooktop with the adhesive side facing down, making
sure that the whole perimeter is sealed but the ends do not overlap. Cut off any excess material.
3
Place the cooktop into the cutout and position it correctly.
4
Adjust the clamps according to the benchtop thickness (see Fig.5), then tighten the fixing screws
until the cooktop is firmly secured.
5
Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the
cooktop. Take care not to damage the benchtop.
Note: if your bench is thicker than 40 mm, recess the underside to 30 or 40 mm.
Fig. 4 Applying the adhesive seal aroound the edges of the cooktop
Fig. 5 Clamp adjustments depending on bench thickness
Adhesive
side
30 mm
40 mm
min
40 mm
min
40 mm