Filter
Top Products
12
Installation instructions
Connecting the cooktop to the mains power supply
Important!
This cooktop must be connected to the mains power supply only by a suitably qualified person.
This cooktop must be earthed.
Before connecting the cooktop to the mains power supply, check that:
1
the domestic wiring system is suitable for the power drawn by the cooktop
2
the voltage corresponds to the value given on the rating plate
3
the power supply cable sections can withstand the load specified on the rating plate.
To connect the cooktop to the mains power supply, do not use adapters, reducers, or branching
devices, as they can cause overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so that its
temperature will not exceed 75
o
C at any point.
Power supply
CE302 3000W @ 220-240V ~ (13 A)
CE604 6000-6500 W @ 230-240/400-415V 3N~ (26-27 A)
Important!
Check with an electrician whether the domestic wiring system is suitable without alterations. Any
alterations must only be made by a qualified electrician.
To connect the power supply cable to the cooktop (CE604 models only) (Fig. 6)
1
Unscrew shield ‘A’ at the bottom of the cooktop.
2
Position the U-bolts ‘C’ onto terminal board ‘B’,
according to the connection diagrams below.
3
Feed the cable through the hole in shield ‘A’.
4
Connect the phase wires to terminal board ‘B’
according to the relevant connection diagram
below, and connect the earth wire to clamp ‘PE’.
5
Tighten the cable and fix it with cable clamp ‘E’.
6
Refit shield ‘A’.
Connection diagrams
Fig. 6 Connecting the power supply cable-CE604 models
E
C
A
B
PE
PE
1 2345
230-240 V
N (L
2
)L
1
PE
1 2345
230-240 V 3
L
1
L
2
L
3
PE
1 2345
N
400-415 V 3N
L
1
L
2
L
3
CE604 models
CE302 models
Single-phase connection Two-phase connection Three-phase connection
PE
N(L )
L1
2