Filter
Top Products
9
Installation instructions
Connecting the cooktop to the gas supply
The gas connection must be carried out by an authorised person according to the relevant
standards.
Before connecting the appliance to the gas main, mount the brass conical adaptor onto the
gas inlet pipe, upon which the washer has been placed (Figs. 5 and 6).
Conical adaptor and washer are supplied with the appliance (packed with conversion kit for
use with Natural gas or LPG).
This appliance is suitable for use with Natural gas or LPG. (Check the “gas type” sticker attached
to the appliance).
For Natural Gas, connect the gas supply to the gas pressure regulator which is supplied with
the appliance (Fig. 5). Adjust the regulator to obtain a test point pressure of 1 kPa with the two
semi-rapid burners operating at the maximum.
For LPG, connect the gas supply to the test point adaptor which is
supplied with the appliance (Fig. 6). Ensure that the supply pressure is regulated to 2.75 kPa.
Do NOT force the ”elbow“ to rotate before loosening the floating nut.
Do NOT overtighten the floating nut at the ”elbow“.
Gas connection for
LPG
Test point adaptor
Washer
Brass conical adaptor
(Thread tight: use
suitable seal)
Gas inlet pipe
Test
point
Gas connection for
NATURAL GAS
Washer
Brass conical adaptor
(Thread tight: use
suitable seal)
Gas pressure
regulator
Test
point
Fig. 5 Natural gas connection
Fig. 6 LPG connection
Elbow Elbow
Gas inlet pipe
Floating nut Floating nut