Filter
Top Products
8
Installation instructions
Fastening the installation brackets (Fig. 4a and 4b)
Each cooktop is provided with an installation kit including brackets and screws for fastening
the cooktop to benches from 20 to 40 mm thick.
Turn the cooktop upside down, place it on a soft surface and fasten the brackets “F and R”
(CG604 models) or “A” (CG905 models) to the appropriate socket holes, without tightening the
screws “B” for the moment (see Figs. 4a and 4b).
Fastening the cooktop (Figs. 4a and 4b)
1
Spread the sealing material “C” out along the edge of the cutout, making sure that the junctions
overlap at the corners.
2
Insert the cooktop into the cutout and position it correctly.
3
Adjust the position of the brackets
“F and R” (CG604 models) or “A” (CG905 models)
and tighten
screws “B” to secure the cooktop firmly in position.
4
Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the
cooktop. Take care not to damage the workbench.
Fig. 4a CG604 models -
Fastening the installation
brackets and the cooktop
Fig. 4b CG905 models -
Fastening the installation
brackets and the cooktop
0
– 2
0
– 2
Gas inlet pipe
Front side
Gas inlet pipe
A
A
A
A
A
A
20 mm min.
40 mm max.
B
C
A
20
mm min.
40
mm max.
B
F
F
F
R
R
20
mm min.
40
mm max.
B
C
R
C
B
Rear side