Filter
Top Products
23
Care and cleaning
Burners and trivets
You can remove and clean these parts with hot soapy water or other appropriate products - see
‘Cleaning chart’.
After cleaning, check that the burners and their flame spreaders are dry before replacing
correctly.
It is very important to check that the burner flame spreader and the cap have been correctly
positioned. Failure to do so can cause serious problems.
Note: to avoid damage to the electronic ignition, do not try to light a burner without all burner
parts correctly in place.
Replacing the burners
It is very important to check that the burner flame spreader and the cap have been correctly
positioned (see Fig. 18). Failure to do so can cause serious problems.
Check that the ignitor (Figs. 18 and 20) is always clean to ensure trouble-free sparking.
In the models with the flame failure safety device, check that the probe (Figs. 18 and 20) next to
each burner is always clean to ensure correct operation of the safety valves.
Both the ignitor and probe must be very carefully cleaned using a toothbrush and methylated
spirits (Fig.15).
Cap
Fig. 18 Correct line-up of auxiliary, rapid and
semi-rapid burner parts
Ignitor
Flame failure
probe
( ame failure
models only)
Flame
spreader
Fig. 19 Replacing the auxiliary,
rapid and semi-rapid burner cap