Filter
Top Products
4
90
o
2” x 4”
DOUBLE MODELS
US CA
Note: Services can be located
either side of DishDrawer®.
Cavity preparation
Parts supplied
Important!
Be sure the edges of the services hole are smooth or covered. If the service hole is through a metal partition
the hole must be protected with the Edge Protector supplied to prevent damage to the power cord or hoses.
These marks indicate mounting tab screw locations
Preferred position. If adequate clearance, services hole can be higher to clear toe kick space.
If hole is higher, ensure drain hose(s) are routed straight into the waste connection.
110-120 VAC
max. 15 A
Moisture
protection
tape must
be applied.
max. ø
1 ½ ” (
38 mm)
*
*
*
min.
7 ⁄”
(
200 mm)
Clamp (1)
Wire clip (2)
Phillips
16 mm
screws (9)
Drain hose
support (1)
Moisture
protection
tape (1)
(to prevent
moisture damage)
Drain hose
joiner (1)
Install
tabs (2)
Prefinished toe kick (1)
White or Black
Washer (1)
Edge Protector (1)
(if service hole
partition is metal)
⁄”
(
10 mm)
max.
17 ⁄”
(
450 mm)
If no side partition,
use a brace for
securing.
If the Drain hose(s) supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit
P/N 525798 which will extend the drain hose(s) by 3.6m. The kit is available from the nearest DCS
Authorized Service Agent, or by phone: 1-888-281-5698, or www.dcsappliances.com. DO NOT extend beyond this limit.
Hexagonal
socket (2)
(Long & Short)
Side flexible
extrusions (2)
Top flexible
extrusion (1)