Filter
Top Products
5
3
1
3
2
1
2
2
MOVE INTO THE CAVITY SECURE THE DRAWER
SECURE THE DRAWER REFIT THE DRAWER
99
10 10
1
4
2
3
5
Before refitting the drawer,
ensure the hoses are not
twisted and the latches at
the rear of each drawer
runner are facing forward.
Ensure the drawer clips on
both sides click into place.
Ensure the drawer is
now rotated
clockwise back.
Pull forward the drawer clips
on both sides 1⁄”(30
mm)
s
l
ot an
d
‘B’
b
rac
k
et must matc
h
‘B’
s
l
ot.
1
2
2
Ensure hoses and cord
are not kinked or twisted.
Open the drawer halfway.
Using a flat-bladed
screwdriver, prise the plastic
gray plug out of the trim
moulding.
Replace the plastic
gray plug back into
the trim moulding and
ensure the trimseal is
facing forward.
Repeat for all four brackets.
Using a small Philips screwdriver,
screw through the trim moulding,
securing the side mounting
bracket to the cabinetry. Do not
damage the rubber trimseal.
The product has three pairs
of fixing points:
(Refer to
4
for relevant parts)
Ensure the sound insulation
is repositioned correctly.
a pair of fixing holes either side on the
bottom
(use 1½ ” (38 mm) fixing screws & washers)
two pairs of formed
brackets on either side
of the chassis
(use ⁄” (16 mm) screws)
(1,2) -2- 599796A DD36S installA2 USCA.indd 19/2/10 11:33:29 AM
(1,2) -2- 599796A DD36S installA2 USCA.indd 19/2/10 11:33:29 AM