Filter
Top Products
SLIDE BRACKETS TO SUITABLE HEIGHT SETTING
RECONNECT CONTROLS REATTACH PANEL
TIGHTEN PANEL BRACKETS
6
89
7
1
2
Electrical Shock Hazard
WARNING !
Connect the ground (earth) wire of the controls
to one of the two tabs provided on the panel bracket.
To ground (earth) the panel bracket, connect the
ground (earth) wire from the product to the other tab.
Failure to follow these warnings may result in
electrical shock, injury or re.
1
2
2
Important!
Ensure the rubber seal
between the drawer and
panel is kept in place.
Push the
panel in then up
to locate.
There are three
pre-drilled
height settings.
Slide brackets to
preferred height setting.
Factory settingLow setting High setting
+ ⁄”(1.5 mm)- ⁄”(1.5 mm)
Tighten these screws
Tighten these screws
Replace these fixing screws
(2,1) -2- 590018A DD36SDD90S DoorPanelPrep USCANZGB.indd 22/2/10 1:50:34 PM
(2,1) -2- 590018A DD36SDD90S DoorPanelPrep USCANZGB.indd 22/2/10 1:50:34 PM