Filter
Top Products
Page DD_06
SECTION 2
FOOT SLIDE RETAINER INFORMATION
STEP 2.1 ASSEMBLING THE FOOT SLIDE RETAINER
It is important that the Foot
Slide Retainer is correctly
installed. It guides the
feet back and holds the
rear of the DishDrawer
down to prevent it rocking
forward when the drawers
are opened. It also aligns
the product to the cavity
front.
The Foot Slide Retainer is made up with one Retainer and two Slide Runners. The
Toe Kick Brace is NOT used in the Foot Slide Retainer.
Be careful of sharp edges.
IMPORTANT
WARNING
2.1.1
Bend the tabs at both ends of the
Retainer so they fit the width of the
cavity for the DishDrawer.
2.1.2
Assemble the Foot Slide Retainer by
forming three sides of a square with the
Retainer and Slide Runners as shown,
ensuring that they fit together. Place in
the cavity.
2.1.3
Using the front of the cavity, create a
center point.
2.1.4
Place the Template in the cavity
ensuring that the template is sitting flat
and lines up with your center point.
IMPORTANT
If there is a drop down in
the cavity, you may have
to build the cavity up
level with the finished
floor.