Filter
Top Products
STEP 5.5 FITTING THE DRAWER FRONT TO THE DISHDRAWER
Use a small amount of
liquid soap along the lip
of the seal to aid the
Drawer Front to slide on
easily against the seal.
The Electronics Board is
an electrostatic sensitive
device. Ensure you are
adequately grounded
when connecting or
disconnecting the badge
by wearing a grounding
strap or by grounding
yourself to the
DishDrawer.
CAUTION
WARNING
TIP
The rubber seal between
the Drawer and Drawer
Front must be kept in
place.
WARNING
Ensure the product is not
plugged in.
I
N
T
E
G
R
A
T
E
D
P
R
O
D
U
C
T
O
N
L
Y
5.5.1
Fit seal to Drawer.
5.5.2
Plug the grounding wire into the panel.
Connect badge wires to integrated badge
port on Electronics Board.
5.5.3
Fit Drawer Front by sliding in an upwards
and inwards motion.
5.5.4
Ensure the slide hooks (on slide) are as far
forward as possible as shown, then insert
pins to lock in place, ensuring that the rib
on the pin is vertical.
Check fit of the Drawer Front and adjust if
required.
INCORRECT
CORRECT
ü
û
Page DS_17
View of Slide Hooks