Fisher & Paykel OB60S9DECP Oven User Manual


 
34
Troubleshooting
Problem Possible causes What to do
Self Clean function
During a Self Clean
cycle, the oven is louder
than usual.
This is normal: the oven’s cooling fans operate at their highest speed.
The display shows
door.
The door has not been properly
closed.
Make sure you close the door
properly.
The display shows
0:00 but the oven door
will not open.
The oven door is locked because
the oven is still too hot to be used
for cooking.
Wait until the Self Clean cycle
has finished. If you cancelled a
Self Clean cycle which was
already underway, the oven
still needs to cool down before
it can be used. The oven door
will automatically unlock.
At a point during a Self
Clean cycle, the function
dial halo goes out
and the temperature
indicator starts
displaying cascading
bars
.
This is normal: the oven is
in the last phase of the Self
Clean cycle, cooling down.
Wait until the Self Clean cycle
has finished. A long tone will
sound and the oven door will
automatically unlock when the
oven is ready to use.
I have cancelled a Self
Clean cycle but cannot
use the oven:
the oven door will not
open
the display is still
counting down
minutes or showing
0:00
the Self Clean
function indicator is
still lit
the temperature
indicator shows
cascading bars
the dials and buttons
are unresponsive.
This is normal: if the function dial
halo is unlit, you have
successfully cancelled the
Self Clean cycle. However, the
oven is still too hot to be
used for cooking and
needs to cool down.
Wait until the cool-down phase
has finished. A long tone will
sound and the oven door will
automatically unlock when the
oven is ready to use.
Note: depending on when the
Self Clean cycle was cancelled,
the cool-down phase may take
up to 45 minutes.
The oven is beeping and
the display shows
or
A3.
See section ‘Alert codes’ for instructions.