Filter
Top Products
15
US
CA
Before you start using your Ice & Water refrigerator
Check refrigerator is switched on and has cooled for at least 2 hours before use (refer to
page19– The temperature of your refrigerator and freezer).
Check that the water filter has been connected and turned on.
Turn on the ice maker (refer to page 24).
At first use allow approximately a minute from when the dispensing pad is pushed until water is
dispensed. This will allow the tank to fill.
Run through and discard the first 3 qt (3 L) of water from the dispenser, stopping intermittently
(refer to page 21 – First use). Failure to do this will result in excessive dripping from yourdispenser.
Discard the first 3 harvests of ice (8 cubes are produced per harvest), refer to page 24 – First use.
You are now ready to enjoy ice and water from your ActiveSmart™ refrigerator.
Fig.15 Water dispenser
Please note that once installation is complete a few drips may appear out of the dispenser over
the next few days as the remaining trapped air is cleared.