Fisher & Paykel RF522A Refrigerator User Manual


 
15
Installation instructions
Before you start using your Ice & Water refrigerator
Check your refrigerator is switched on and has cooled for at least 2 hours before use (refer to
page 21 – Temperature control).
Check that the isolation tap has been connected and turned on.
The first time you use your water dispenser, there will be a 1 – 2 minute delay while the tank
fills until water is dispensed. Run through and discard the first 3 litres (3 qt) of water, stopping
intermittently to remove trapped air in the system. Failure to do this will result in excessive
dripping from your dispenser.
Turn the ice maker on by pressing the button (refer to pg 29). The light above the button
will be illuminated when the ice maker is on.
Press and hold the , and buttons together for 4 seconds and then close the
refrigerator compartment door to force an ice maker cycle. The ice tray will flip twice. Repeat
to force another ice maker cycle. The ice tray will flip twice and spill water into the ice bin.
Empty the water, dry and replace the bin. Note that the ice tray will not flip until the refrigerator
compartment door is closed.
Please discard the first 3 harvests of ice (8 cubes per harvest).
You are now ready to enjoy ice and water from your ActiveSmart™ refrigerator.
Fig.10 Water dispenser
Please note that once installation is complete a few drips may appear out of the dispenser over
the next few days as the remaining trapped air is cleared.