Filter
Top Products
41
Troubleshooting
Ice and water
Problem Possible causes What to do
No indicator lights
are lit on dispenser
control.
Freezer door is not closed. Verify that freezer door is closed. Power is
removed from the control when freezer door
is opened.
Refrigerator is not plugged
in.
Plug in refrigerator.
Fuse is blown, or circuit
breaker needs to be reset.
Replace any blown fuses.
Check circuit breakers for any tripped
circuits.
Power outage has occurred. Call local power company listing to report
outage.
Refrigerator is in Sabbath
Mode (select models).
See Sabbath Mode, page 15.
Ice or water are not
dispensed when
pads are pressed.
Freezer door is not closed. Verify that freezer door is closed. Power is
removed from the control when freezer door
is opened.
Controls are in Lock Mode. See dispenser Lock, page 21.
Water tank is filling. At initial use, there is an approximate one-to
two-minute delay in dispensing while the
internal water tank is filling.
Ice bin not installed
properly.
Reinstall ice bin (see page 23).
Ice maker has just been
installed or a large amount
of ice has been used.
Wait 24 hours for ice production to begin or
for ice maker to restock after emptied.
Water pressure is too low. Water pressure must be between 35 to 100
pounds per square inch to function properly.
A minimum pressure of 35 pounds per
square inch is recommended for refrigerators
with water filters.
Water filter is clogged or
needs to be changed.
Change water filter (see page 25).
EN