Filter
Top Products
14
Food Network
15
Food Network
Setting the AUTO Start Time
1. Press the PROG button until the word “TIMER” appears in the upper left
corner of the display window to indicate that you are in the future AUTO
time setting mode.
2. Press the HOUR button, then the MIN button to set the future AUTO
start time; release the buttons to advance one digit at a time. Hold down
the HR or MIN buttons to fast advance.
Note: Pay attention to the AM and PM setting.
Note: If no buttons are pressed after 5 seconds, the setting mode will expire and
the LCD will display the current time.
3. When the desired future AUTO start time appears in the display window,
press the AUTO button. The blue AUTO indicator light will illuminate.
WARNING: Make sure the Coffee Maker is set up to brew coffee: Fill the
water reservoir at least to the 2-cup level, add fresh ground coffee to a
clean coffee fi lter and close the lid. Place the empty carafe in position on
warming plate
4. When the preset time is reached, the AUTO indicator light will turn off;
the BREW indicator light will illuminate and the Coffee Maker will begin
brewing coffee.
5. When brewing is complete, the Coffee Maker will advance to a 2 hour
KEEP WARM mode. The BREW indicator light will remain illuminated.
6. To cancel the preset AUTO start time, press the OFF button to turn the
Coffee Maker OFF. Press the ON button and the Coffee Maker will begin
the brew cycle immediately.
7. To change the preset AUTO start time, simply press the PROG button
twice until “TIMER” appears in the upper left corner of the display
window. Then press the HOUR button the MIN button until the new
AUTO future start time is displayed. Activate the AUTO feature by
pressing the AUTO button until the blue AUTO indicator light illuminates.
Hints for Great-Tasting Coffee
• A clean Coffee Maker is essential for making great-tasting coffee. Regular
cleaning, as described in the Care & Cleaning Instructions and Descaling
sections of this owner’s manual is highly recommended.
• Always use fresh, cold water in your Coffee Maker.
• Finer grinds, such as drip and ADC coffee, promote fuller extraction and
provide rich, full-bodied coffee. Regular grind will require slightly more
coffee per cup to provide the strength of a fi ner grind.
• Store coffee in a cool, dry place. Once coffee has been opened, keep it tightly
sealed in the refrigerator to maintain freshness.
• For optimum coffee, buy whole beans and grind them fi nely just
before brewing.
• Do not re-use coffee grounds since this will greatly impair coffee fl avor.
• Reheating coffee is not recommended. Coffee is at its peak fl avor
immediately after brewing.
• Small oil droplets on the surface of brewed, black coffee is due to the
extraction of oil from the coffee grounds. Oiliness may occur more
frequently if heavily roasted coffees are used. Overextraction may also cause
oiliness, indicating a need to clean your Coffee Maker.
AutoPause & Serve
1. After approximately 2 cups of coffee have been brewed, the carafe may
be slowly removed and the coffee will stop dripping.
2. The fl ow valve is located on the bottom of the fi lter holder and is activated
when the carafe is removed. The design makes it possible for you to remove
the carafe and pour a cup of coffee before the entire carafe is brewed.
3. IMPORTANT: When replacing the fi lter holder, the fl ow valve must be
properly inserted into the front hole of the machine, so that it can be seen
as it sits on the top of the carafe lid.
4. When using this feature, make sure that the carafe is replaced under
the fi lter holder within 30 seconds to prevent overfl ow.