Filter
Top Products
INSTRUCTIONS FOR INSTALLATION OF THE UNIT
All tasks involved in installing the applianc
e must be carried out by a skilled professional.
Any work is to be performed with the appliance unplugged.
Electrical connection:
make sure that the voltage corresponds to that indicated on the lable on the side.
The oven must be connected using a cable with a
minimum cross
-
section of 1.5 mm
on the rear, and with an omni-
polar switch compliant with current standards with a
distance of aperture between contacts of at least 3 mm.
Attention: earth connection is required by law.
The manufacturer will in no way be
held liable if accident prevention standards area
not observed.
Insertion into the furniture unit:
The appliance can be inserted either under a worktop or into a column. In either case
comply with the dimensions shown in figures 1 and 2.
For column instal
lation, in order to ensure proper ventilation, it is very important to
provide an opening of at least 85
-
90mm as shown in figure 1.
The oven is secured to the furniture unit by four screws A located in the holes of
the perimeter frame (see fig. 1).
Do n
ot
use the door as a lever when installing the oven.
Do not place excessive pressure on the oven door when it is open.
Before using the oven for the first time
After unpacking the oven, installing it in the furniture unit and removing the
accessories (drip pan and racks), it is advisable to run it at the highest temperature for
about 20 minutes to remove any oily residues left from the manufacturing process
which may cause unpleasant odours during cooking. Aerate the room while doing
this. Wash the drip pan and racks with washing up liquid.
For the first few minutes that the oven is in operation, condensation may form on the
front. This does not in any way compromise operation of the unit.
24