Filter
Top Products
26
WH
AT TO DO IN CASE OF A PROBLEM
The
symbol [ E 4 ] displays :
Th
e hob must be configured according to the following procedure.
I) Warning : before starting all pots must be removed from the cooktop.
II) Disconnect the cooktop from the main supply : remove fuse or disconnect circuit breaker.
III) Connect the cooktop to the main supply : replace the fuse or connect the circuit breaker.
IV) Procedure : You must provide yourself with a ferromagnetic bottom container 16 cm
minimum diametre.
* start within 2 minutes after the connection to the main supply
* do not use the [ O/I ] key.
V) How to cancel the existing configuration :
1) 7331230 : Push on key [ - ] and keep your finger on
the key
7370230 : Push on key [ 1 ] and keep your finger on
the key
2) With a finger from the other hand : activate anti-
clockwise successively and quickly all other existing
[ + ] keys. Start with the front right cooking zone and
move anti-clockwise (a -> b -> c -> d). A double "beep"
sound will inform you of a bad manipulation and you
will have to restart from point 1.
3) Take your fingers off the touches and re-touch and hold down [ - ] for a few
seconds, until blinking [ E ] appears.
4) Wait until [ E ] becomes permanent.
5) The [ E ] will be transformed automatically into [ C ]. The configuration has been
done.
Nota : Cooktops with 3 heating zones : Start the procedure with the rear right [ + ]
key (b) ( the front right zone doesn't exist...)
VI) How to configure the hob ?
1) Use a suitable induction pot with a minimum diametre size of 16cm.
2) Select the heating zone by pushing the corresponding [ + ] key.
3) Put the pot on the corresponding heating zone.
4) Wait until [ C ] converts to [ - ]. The zone is configured
5) Use the same procedure for each other heating zone which displays [ C ]
6) The configuration is made if all zones are detected and if nothing is displayed
Use only 1 pot to configure the hob.
Never put two or more pots on the heating zones during the configuration.
If [ E 4 ] display persists call the After-sales Service
The hob or the cooking zone doesn’t start-up :
Th
e hob is badly connected on the electrical network.
The protection fuse cut-off.
The looking function is activated.
The sensitive keys are covered of grease or water.
An object is put on a key.
The control panel displays
[ U ]
:
There is no pan on the cooking zone.
The pan is not compatible with induction.
The bottom diameter of the pan is too small.
a
d
c
b