Filter
Top Products
EN
1
0
10
4.If using the rear electrical knockout, drill a 1”1/4 hole through the wall at the location shown.
HOOD size A
36” 14” 3/16
48” 20” 1/4
5. If using the top electrical knockout, drill a 1“ 1/4 hole through the hood support at the loca-
tion shown.
6. Remove the filters one at a time holding them up with one hand and pulling the handle
downwards with the other hand at the same time.
7.Disconnect power
8. Remove the terminal box cover located behind the right hand filter.
9. Install UL or CSA listed strain relief in hood so that screws can be tightened.
A
2”
Centerline of hood
Hood support
(front view)
Hood support
(top view)
Right rear hood
mounting hole
2”
1”1/2