Franke Consumer Products FTU 3807 I Cooktop User Manual


 
EN
2
1
21
FIXING THE FRAME
Unfasten the two screws fastening the upper chimney
stack 2.1 to the frame, and remove the chimney from
the upper stack.
If you wish to adjust the height of the frame, proceed as
follows:
Unfasten the four safety screws located at the top in
the frame separation area. (A)
Unfasten the eight metric screws joining the two col-
umns, located at the sides of the frame. (B)
Adjust the frame to the height required, then replace
all the screws removed as above.
To guarantee greater stability in the frame, replace
the four safety screws in the last hole available.
Insert the upper chimney stack from above, and leave
it running free on the frame.
Lift the frame up, making sure that the index over the
frame plate is turned backwards.
Fit the frame slots onto the two screws inserted in the
ceiling as above, and turn until reaching the centre of
the adjustment slot.
Tighten the two screws and fasten the other two
screws provided; before locking the screws com-
pletely, it is possible to adjust the frame by turning it,
making sure that the screws do not come out of their
housing in the adjustment slot.
The Frame must be securely fastened so as to support
both the weight of the Hood and the stress caused by
occasional axial pres
sure against the fitted Appliance.
After fixing, make sure that the base is stable even
when the Frame is subjected to lateral stress.
If the Ceiling is not strong enough in the area where
the hood is to be fixed, the Installer must strengthen
the area using suitable plates and counterplates an-
chored to resistant structures.
A
B
2
1
1
2