Franke Consumer Products FTU 3807 I Cooktop User Manual


 
EN
2
3
23
Fitting the Upper Chimney and the Hood Body
Position the upper chimney stack and . x the top of it to the
frame using 2 of the screws removed as above.
Open the lighting unit by pulling on the notch, disconnect it
from the hood canopy by sliding out the pin.
Remove the filters one at a time by pushing them towards the
back of the group and pulling down at the same time.
Remove the activated charcoal filters, if fitted.
In order to fix the hood body to the frame insert the 4 screws
12f in their seats. It is necessary to leave at least 4-5 mm gap
between the screw heads and the frame plate.
Hook the hood canopy to the frame and turn it to the left until
it reaches the stop, then lock the screws immediately to prevent
the hood canopy from falling out accidentally.
Recirculation version
Make sure that the outlet of the extension piece 14.2 is hori-
zontally and vertically aligned with the chimney outlet.
If this is not the case, remove the lower Chimney Stack and
adjust the position of Extension 14; replace the elements as de-
scribed above.
Insert Connector Extension 14.1 sideways into Extension 14.2.
Fit the directional grill 8 into the housing provided. Also make
sure that it is properly fitted into connector 14.1.
8
14.1
2
1
ELECTRICAL CONNECTION
Connect the Hood to the mains power supply, inserting a two-
pole cut-out switch with contact aperture of at least 3 mm
along the line.
Ensure that the supply cable connector is properly inserted into
the Suction device socket
Hook up the Commands connector Cmd.
Hook up the Spotlights connector Lux to the socket provided
behind the lighting unit cover.
For the Recirculation Version, fit the Activated Charcoal
Odour Filter.
Replace the filters and the lighting unit.
Cmd
Lux