Filter
Top Products
Care and Cleaning
Burn Hazard
Allow heating element to cool
before cleaning the interior•
Failure to do so can result in
burns.
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher, check to make sure it is clean so the
dishwasher will drain properly. A drain air gap is
usually mounted on countertop and can be
inspected by removing the cover. This is not part
of your dishwasher and is not covered by
warranty.
f"%_LA.=JA
IJUL_lU_---Occasionally wipe with a mild
nonabrasive detergent and water. Rinse and dry.
Inside--The inside of the dishwasher,
including the filter, is self-cleaning with normal
use• If needed, clean around the tub gasket area
with a damp cloth.
Property Damage Hazard
Freezing temperatures may cause water lines to
rupture• Be sure all supply lines to and circulating
lines within dishwasher are protected•
Failure to do so could result in property damage.
Heating el
Filte_ir
Spray arm/tower assembly
......... Winterizing
A dishwasher left in an unheated place should
be protected from freezing. Have a qualified
_. person do the following:
....... To Disconnect Service:
• Turn off electrical power to the dishwasher at
the supply source by removing fuses or
tripping circuit breaker.
2. Shut off water supply.
Note: Hard water may cause lime deposit buildup
on the interior of the dishwasher. For cleaning
instructions see "Removing Spots and Film"
section.
Overfill Protector--keeps dishwasher
from overfilling and is located in the left front
corner of the tub.
• Clean occasionally
with household
cleaner containing
vinegar or
bleach to dissolve
any buildup.
• Overfill Protector _
should move up and
down freely about
one inch. If it does
not move, lift and clean underneath.
3. Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain
water into pan.
Note: See Installations Instructions for more
details.
To Restore Service:
1. Reconnect the water, drain, and electrical
power supply•
2. Turn on water and electrical power supply•
3. Fill detergent cup(s) and run dishwasher
through a NORMAL cycle•
4. Check connections to make sure they do not
leak.
Note: See Installations Instructions for more
details•