![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/7/d4/7d4698ad-f9d0-405c-8b8f-3fa6a162e81b/7d4698ad-f9d0-405c-8b8f-3fa6a162e81b-bgf.png)
15
Yourrefrigeratorisequippedwithwaterlteringsystem.
Thewaterltersystemltersalldispenseddrinking
water, as well as the water used to produce ice.
Thewaterlterislocatedatthetoprightsideofthe
fresh food compartment.
Toorderyourreplacementlters,pleasevisitouronline
store at www.frigidaire.com/store, by calling toll-free
at 877-808-4195, or by visiting the dealer where you
purchased your refrigerator. Electrolux recommends
thatyouorderextralterswhenyourstinstallyour
refrigerator,andthatyoureplaceyourltersatleastonce
every six months.
Here is the product number to request when ordering:
TM
Water Filter
Part #
Ingeneral,youshouldchangethewaterltereverysix
months to ensure the highest possible water quality.
on the user interface prompts you
toreplacethelterafterastandardamountofwater
(200 gallons/757 liters for
TM
)
hasowed
through the system.
If your refrigerator has not been used for a period of time
(duringmovingforexample),changethelterbefore
reinstalling the refrigerator.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
orafterthesystem.Systemscertiedforcystreduction
may be used on disinfected waters that may contain
lterablecysts.
• RatedCapacity-200gallons/757litersfor
TM
iceandwaterlter
• Ratedserviceow-.50gallonsperminute
• OperatingTemp.:Min.33°F,Max.100°F
• MaximumRatedPressure-100poundspersquare
inch
• RecommendedMinimumOperatingPressure:30
pounds per square inch
TM
It is not necessary to turn the water supply off to change
thelter.Bereadytowipeupanysmallamountsofwater
releasedduringthelterreplacement.
Turn the ice maker power switch.
2 Removethelterbypushingontheend/faceofthe
lter.
3 Slidetheoldwaterltercartridgestraightoutofthe
housing and discard it.
4 Unpackagethenewltercartridge.Usingthe
alignmentguide,slideitgentlyintothelterhousing
until it stops against the snap-in connector at the
back of the housing.
Press a drinking glass against the water dispenser
whilecheckingforanyleaksatthelterhousing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.
7 Afterllingoneglassofwater,continueushingthe
system for about .
8 Turn the ice maker.
9 Press and hold the button on the Ice
& Water Dispenser control panel for three seconds.
When the display changes from to , the
status has been reset.
The
TM
iceandwaterlter
systemistestedandcertiedtoNSF/ANSI
Standards 42 and 53 for the reduction of claims
speciedontheperformancedatasheet.