Filter
Top Products
5
Your model may be equipped with the clock and minute timer shown below.
To set the clock and minute timer, follow these instructions:
To Set the Clock
When the range is first plugged in, or when the power supply to the range has
been interrupted, "12:00" will flash in the display window.
1. Slide switch C (CLOCK/TIMER) to the CLOCK position.
2. Push in and hold button A (HOUR) until the correct hour appears in the
display. (The numbers will only count forward.)
3. Push in and hold button B (MINUTE) until the correct minutes appear in the
display.
To Set the Minute Timer
1. Slide switch C (CLOCK/TIMER) to the TIMER position, "0:59" (59 MINUTES) will
appear in the display window. The timer can be set for any amount of time
from 1 minute to 1 hour and 59 minutes.
2. To set a time more than 59 minutes, push in and release button A (HOUR).
The timer will jump in at the maximum 1 hour and 59 minutes. The time
can now be adjusted down by pushing in and holding button B (MINUTE)
until the correct time appears in the display window.
To set a time less than 59 minutes, push in and hold button B (MINUTE)
until the correct minutes appear in the display. (The minute timer will
automatically start when the button is released.)
3. When the set time has passed, the control will display "0:00" and beep
continuously. Slide switch C (CLOCK/TIMER) to the CLOCK position to cancel
the timer and return to the clock mode.
Setting the Clock and
Minute Timer
(some models)
Grounding Instructions
(electric ignition models only)
IMPORTANT: READ AND SAVE THESE INSTRUCTIONS.
This appliance is equipped with a 3-prong grounding plug for
your protection against shock hazard and should be plugged directly into a
properly grounded receptacle. DO NOT cut or remove the grounding prong
from this plug.
For personal safety, the range must be properly grounded. For maximum
safety, the power cord must be plugged into an electrical outlet that is correctly
polarized and properly grounded.
If a 2-prong wall receptacle is the only available outlet, it is the personal
responsibility of the consumer to have it replaced with a properly grounded 3-
prong wall receptacle installed by a qualified electrician.
DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD ROUND
GROUNDING PRONG FROM THE POWER CORD PLUG. SEE THE INSTALLATION
INSTRUCTIONS PACKAGED WITH THIS RANGE FOR COMPLETE INSTALLATION
AND GROUNDING INSTRUCTIONS. DO NOT OPERATE THE RANGE USING A 2-
PRONG ADAPTER OR AN EXTENSION CORD.