12
OCCURRENCE
Oven Control Beeps and Displays -F1-
through -F10-.
-F8- is displayed.
Installation.
Entire oven does not operate.
Oven light does not work.
POSSIBLE CAUSE/SOLUTION
Electronic control has detected a fault condition. Push CANCEL pad to clear the display and
stop the display from beeping. Reprogram the oven. If a fault reoccurs, record the fault
number, push the CANCEL pad and contact an authorized servicer.
The door was left open and controls set for self-cleaning cycle. Close the door and push both
upper and lower oven CANCEL pads.
Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent if
rack and cabinet cutout flooring are not level.
Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets are
square and level. Contact cabinet maker to correct problem.
When the oven is first plugged in, or when the power supply to the oven has been interrupted,
the display will flash. The oven cannot be programmed until the clock is set.
Be sure electrical cord is securely connected into the electrical junction box.
Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact your
dealer, installing agent or authorized servicer.
Service wiring not complete. Contact your dealer, installing agent or authorized servicer.
Power outage. Check house lights to be sure. Call your local electric company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions under Setting Oven Controls to set the
controls.
House fuse has blown or circuit breaker has tripped immediately following installation. House
fuse may not be fully engaged. Check fuse and screw or engage circuit breaker securely.
House fuse has blown or circuit breaker has tripped after the oven has been
installed and previously operating. Call an authorized servicer.
Burned-out or loose bulb. Follow the instructions under Changing Oven Light to replace or
tighten the bulb.
Avoid Service Checklist
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that
are not the result of defective workmanship or materials in this appliance.