Filter
Top Products
9
OCCURRENCE
Poor installation. Place a level on the cutout bottom. Make sure bottom is level.
Be sure cutout bottom is strong and stable enough to adequately support drawer (and
wall oven, if applicable).
easily. Appliance must be
Cabinets not square or are built in too tightly. Contact builder or installer to make
appliance accessible.
Warmer drawer does not
operate.
Make sure cord/plug is plugged tightly into outlet.
Service wiring is not complete. Contact Sears or another qualied servicer.
Power outage. Check house lights to be sure. Call your local electric company for
service.
An error at power up (or after a power failure) could happen if the control knob was
left on the ON position. If a power failure should occur, be sure to set the control
knob to the OFF position. This will reset the electronic controls.
Once the control knob has been set to the OFF position, the electronic controls
should return to normal operation.
(Solutions to Common Problems)
IMPORTANT
review this list. It may save you time and expense. The list includes common
occurrences that are not the result of defective workmanship or materials in this appliance.