Filter
Top Products
27
SETTING OVEN CONTROLS
How the Electronic Surface Element Controls
work when the Sabbath feature is ON.
When your Oven Sabbath feature is ON, the Electronic
Surface Elements are also in Sabbath mode. This means
that all electronic surface element control displays show
“Sb”. The surface elements can be used even if the Sabbath
Feature is on.
If you turn on a surface element when the oven Sabbath
feature is on, the electronic surface element control will record
that request and execute it with a 15-30 seconds delay. So
the element will start heating 15-30 seconds after the surface
element control was turned on. As the oven control, the
surface element display will not show the setting because
“Sb” is on in the displays. When necessary, it is possible to
adjust the power of the surface element but you have to
remember that the surface element control will adjust the
temperature with the same delay.
To shut off the surface element while the Sabbath feature
is ON, proceed as usual but take note that the element will
immediately turn off without any delay.
(for use on
the Jewish Sabbath & Holidays)
The and DELAY START pads are used to
set the Sabbath feature. The Sabbath feature may only be
used with the pad. The oven temperature may be
set higher or lower after setting the Sabbath feature (the
oven temperature adjustment feature should be used only
during Jewish Holidays), however the display will not visibly
show or provide any audible tones indicating whether the
change occurred correctly. Once the oven is properly set
using Bake with the Sabbath feature active, the oven will
remain continuously ON until cancelled. This will override
the factory preset 6-Hour Energy Saving feature.
If the oven light will be needed during the Sabbath, press
OVEN LIGHT before activating the Sabbath feature.
Once the oven light is turned ON and the Sabbath feature
is active, the oven light will remain ON until the Sabbath
feature is turned OFF. If the oven light needs to be OFF,
be sure to turn the oven light OFF before activating the
Sabbath feature.
IMPORTANT
It is not advised to attempt to activate any other program
feature other than while the Sabbath feature is
active. ONLY the following key pads will function after
setting the Sabbath feature; 0 to 9, , START &
CANCEL. All other keypads should not be used once
the Sabbath feature is properly activated.
NOTE
You may change the oven temperature once baking has
started by pressing , the numeric key pads for the
temperature you want (example for 425°C press 4 2 5)
and then pressing START twice (for Jewish Holidays
only). Remember that
beep or display any further changes once the oven
is set for the Sabbath feature.
(example: baking at 350°F)
1. Be sure that the clock is set with the correct time of day.
2. Place the food in the oven.
3. Press UPPER OVEN or LOWER OVEN to select oven.
4. Press . “” appears in the display.
5. Press START. The actual oven temperature appears in
the display.
6. If you desire to set the oven control for a
or do so at this time. If not, skip
this step and continue to step 8. Refer to the
Time / Delay Start section for complete instructions.
Remember the oven will shut down after using
Time or Delay Start and therefore may only be used
once during the Sabbath/Jewish Holidays. The maximum
time is 11 hours & 59 minutes.
7. The oven will turn ON and begin heating.
8. Press and hold both the and DELAY START
pads for at least . “SAb” will appear in the
display. Once “SAb” appears in the display the oven
control will no longer beep or display any further changes
and the oven is properly set for the Sabbath feature.
9. The oven may be turned OFF at any time by rst pressing
CANCEL pad (this will turn the oven OFF only). To turn
OFF the Sabbath feature press and hold both the
TIME and DELAY START pads for at least .
“SAb” will disappear from the display.
Should you experience a power failure or interruption, the
oven will shut off. When power is returned, “SF” (Sabbath
Failure) will be shown in the oven display and the cooktop
displays. The oven and cooktop will not turn back on
automatically. If your food was nearly fully cooked, you
may allow the trapped heat in the oven to nish the cooking
process. Otherwise, you should remove the food when the
power failure occurs, because you may only start the oven
once during the Sabbath/Jewish Holidays. After the Sabbath
observance turn OFF the Sabbath feature and the oven may
be used with all normal functions.
After the Sabbath observance turn OFF the Sabbath feature.
Press and hold both the and DELAY pads for at
least . “SAb” will disappear from the display and
the oven may be used with all normal functions. For further
assistance, guidelines for proper usage, and a complete list
of models with the Sabbath feature, please visit the web at
http:\\www.star-k.org.