Filter
Top Products
12
Outside—Occasionally wipe with a mild,
nonabrasive detergent and water. Rinse and dry.
Inside—The inside of the dishwasher is self-
cleaning with normal use. If needed, clean around
the tub gasket area with a damp cloth.
Overfill Protector—keeps dishwasher from
overfilling and is located in the right front corner of
the tub.
• Clean occasionally
with household cleaner
containing vinegar to
dissolve any buildup.
• Overfill protector should
move up and down freely
about one inch. If it does
not move, lift and clean
underneath.
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher, check to make sure it is clean so
the dishwasher will drain properly. A drain air gap
is usually mounted on countertop and can be
inspected by removing the cover. This is not part of
your dishwasher and is not covered by warranty.
Note: Hard water may cause lime deposit buildup
on the interior of the dishwasher. For cleaning
instructions see “Removing Spots and Film”
section.
Winterizing
A dishwasher left in an unheated place should be
protected from freezing. Have a qualified person
do the following:
To Disconnect Service:
1. Turn off electrical power to the dishwasher at
the supply source by removing fuses or turning
off the circuit breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain
water into pan.
Note: See Installation Instructions for more
details.
To Restore Service:
1. Reconnect the water, drain, and electrical
power supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher
through a Heavy Wash cycle.
4. Check connections to make sure they do not
leak.
Note: See Installation Instructions for more
details.
Property Damage Hazard
Freezing temperatures may cause water lines to
rupture. Be sure all supply lines to and
circulating lines within dishwasher are protected.
Failure to do so could result in property damage.
Allow heating element to cool
before cleaning the interior.
Failure to do so can result in
burns.
Burn Hazard
Care and Cleaning