Filter
Top Products
Setting Continuous Bake or 12 Hour Energy Saving
The KITCHEN TIMER @ and CLEAN ) pads controlthe Continuous Bake or 12 Hour Energy Saving features. The
oven control has a factory preset built-in 12 Hour Energy Saving feature that will shut off the oven if the oven control is left
on for more than 11 hours and 59 minutes. The oven can be programmed to override this feature for Continuous Baking.
INSTRUCTIONS PRESS DISPLAY
To set the control for Continuous Bake or 12 Hour
Energy Saving features:
1. Press and hold @ for 7 seconds (Fig.l). ":12" or ":- -" wilt
appear in the display and the control will beep once.
2.
Press ) to switch between the 12 Hour Energy Saving and
continuous bake features. Note: ":12" in the display indicates
the control is set for the 12 Hour Energy Saving mode and ":- -"
indicates the control is set for the Continuous Bake feature
(Figures 2 and 3).
3. Press Ito accept the change (Fig. 4; display will return to
for 7 seconds
@
Figure 1
time of day) or press _ to reject the change.
Figure 2
O or _ Figure 3
Figure 4
Setting Kitchen Timer
The KITCHEN TIMER @ pad controls the Kitchen Timer feature. The Kitchen Timer serves as an extra timer in the
kitchen that wilt beep when the set time has run out. It does not start or stop cooking. The Kitchen Timer feature can be
used during any of the other oven control functions. Refer to the "Minimum and Maximum Control Pad Settings" on page
15 for the time amount settings.
INSTRUCTIONS PRESS DISPLAY
To set the Kitchen Timer (example for 5 minutes):
1. Press @. "0:00" wiltappear and "TIMER" will flash in the
display (Fig. 5).
2. Press the number pads to set the desired time in the display
(example (_). Press i_. The time will begin to count down
(Fig. 6) and "TIMER" wilt appear in the display. Note: If _ )is
not pressed the timer wilt return to the time of day.
3. When the set time has run out, "End" will show in the display
(Fig. 7), and 3 beeps every 60 seconds will sound until @ is
pressed.
®O
@
To cancel the Kitchen Timer before the set time has
run out:
Press @. The display will return to the time of day.
@
15
Figure 5
Figure 6
Figure 7