Filter
Top Products
30
To Remove and Replace the Surface Burner Grate, Surface Burner Cap and
Surface Burner Head - Remove in the following order; (1st) Center Burner Grate,
(2nd) Surface Burner Grate, (3rd) Surface Burner Cap, (4th) Surface Burner Head
(See Fig. 1).
Reverse the procedure above to replace the Surface Burner Cap, Surface Burner
Head and Surface Burner Grate. Do not remove any burner parts from the
cooktop until the burner parts have completely cooled and are safe to handle.
Do not operate the surface burners without the Surface Burner Caps, Surface
Burner Heads and Surface Burner Grates properly in place.
To Clean the Burner Caps, Burner Heads and Burner Grates - Use a soap-filled
scouring pad or a mild abrasive cleanser to clean the surface burner caps and
surface burner heads. The ports (or slots) around the burner heads must be
routinely cleaned. If residue still remains in these ports, use a small-gauge wire
or needle to clean the slots or holes. For proper flow of gas and ignition of the
burner—DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY
OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING.
ALWAYS keep the surface burner cap and surface burner head in place whenever
a surface burner is in use.
Cleaning the Burner Grates, Burner Caps and Burner Heads
The Burner Grates, Burner Caps and Burner Heads should be routinely cleaned.
Keeping the burner ports clean will prevent improper ignition and an uneven flame
at each burner position. Refer to the following instructions.
Figure 1
Care & Cleaning
To Remove Warming Drawer:
1. Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (See Fig. 2).
5. Pull the Warming Drawer away from the range.
To Replace Warming Drawer:
1. Pull the bearing glides to the front of the chassis glide (See Fig. 3).
2. Align the glide on each side of the drawer with the glide slots on the range.
3. Push the drawer into the range until levers “click” (approximately 2”). Pull the
drawer open again to seat bearing glides into position. If you do not hear the
levers “click” or the bearing glides do not feel seated remove the drawer
and repeat steps 1 thru 3. This will minimize possible damage to the bearing
glides.
Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
Removing and Replacing the Warming Drawer (some models)
NOTE: The Warming Drawer will NOT operate while in the “Self-Clean” and “Oven
Lockout” modes.
Care & Cleaning of Stainless Steel (some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the
appearance of stainless parts. Please refer to the Cleaning Chart provided at the beginning of the Care & Cleaning section
in this Use & Care Manual.
Figure 2
Figure 3