Filter
Top Products
8
Your gas range was supplied with 4 different surface gas burners; a
"SIMMER" Burner (5,000 BTU), a STANDARD burner (9,500 BTU), a
"POWER" Burner (12,000 BTU) and a POWER PLUS™ Burner (14,000 BTU).
When setting up the gas range for the first time, make sure that the correct
Burner Heads, Burner Caps and Burner Grates are correctly (See Fig. 1).
Assembly of the Surface Burner Heads, Burner Caps and
Burner Grates:
It is very important to makes sure that all of the Surface Burner Heads,
Surface Burner Caps and Surface Burner Grates are installed correctly and in
the correct locations.
1. Place all 4 Burner Heads in the correct locations (See Fig. 1). Make sure
that the correct Burner Head is placed with the corresponding Orifice
Holder and that the Electrode is located properly in the slot provided of
each Burner Head (See Fig. 2). Proper Burner Head placement insures that
each Burner will have the correct spark required for gas ignition.
2. Place the correct Burner Caps at each of the burner locations. Each of the
4 Burner Heads MUST have a Burner Cap installed to insure proper ignition
and gas flame size before placing the Burner Grates (See Fig. 2).
3. Place the 4 cast iron surface Burner Grates supplied with the range. After
the surface grates been installed place the center grate between the four
grates and be sure to interlock the grates correctly (See Fig. 3).
REMEMBER — DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR
ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER
OPENING. Always keep the Burner Caps and Burner Heads in place whenever
the surface burners are in use.
Figure 1
Figure 2
Sizes of the Surface Gas Burners
Figure 3
Setting Surface Controls