Filter
Top Products
4
Washer on pedestal: Dryer on pedestal:
Attach pedestal to appliance
Installing or re-installing appliance
Turn pedestal on its side to match orientation to appliance.1.
Slide pedestal up to appliance and line up holes in mounting 2.
brackets with holes in appliance base.
Attach rear and front brackets to appliance base with supplied 3.
screws into aligning holes - one in each front bracket and two in
each rear bracket.
Slide washer/pedestal into place.1.
Check for levelness and rock all four (4) legs again. Repeat until 2.
level and solid.
Refer to 3. Washer Installation Instructions for complete details
on installing water, drain, or electrical.
Slide dryer/pedestal into place.1.
Check for levelness and rock all four (4) legs again. Repeat until 2.
level and solid.
Refer to 3. Dryer Installation Instructions for complete details on
installing electrical, gas, or exhaust venting.
DO NOT use open dispenser drawer of washer
or dispenser cavity as hand-hold location when tipping washer
upright. Serious damage could occur to your washer.
Using more than one person, carefully return appliance and ped-4.
estal to upright position.
After retuning appliance upright, loosen each mounting screw 5.
going into appliance base. Allow the appliance to settle in the
brackets and retighten each mounting screw.
Special instructions for mounting
a dryer with side pane style of 2 indents
and 4 inch knockout (see image to right).
Rear bracket mounts to dryer with wide tabs on bracket •
into slots on rear of dryer.
Engage hook tabs of rear bracket into slots of dryer be-•
fore aligning front bracket with holes in dryer base.
Continue with instructions below for attaching front •
bracket to dryer base.
SLOT in rear
of dryer
Wide hook TAB
on rear bracket
- EXCESSIVE WEIGHT HAZARD - To avoid back
or other injury, have more than one person move or lift the
appliance.