26
CLEANING AND CARE
(Front of microwave oven)
(Rear of microwave oven)
Grease filters
Tabs
BOTTOM VIEW
EXTERIOR
The outside surface is precoated steel and plastic. Clean
the outside with mild soap and water; rinse and dry with
a soft cloth. Do not use any type of household or abrasive
cleaner.
DOOR
Disconnect the power cord or deactivate the oven with
setting Child Lock before cleaning to prevent unexpected
manipulation. See Child Lock on page 23. Wipe the window
on both sides with a soft cloth to remove any spills or
spatters. Metal parts will be easier to maintain if wiped
frequently with a soft cloth. Avoid the use of spray and
other harsh cleaners as they may stain, streak or dull the
door surface.
EASY CARE™ STAINLESS STEEL
(SOME MODELS)
Your microwave oven finish may be made with Easy Care™
Stainless Steel (some models). Clean the stainless with warm
soapy water using a clean sponge or cloth. Rinse with clean
water and dry with a soft clean cloth. DO NOT use ANY store
bought cleaners like Stainless Steel cleaners or any other
types of cleaners containing any abrasive, chlorides, chlorines
or ammonia. It is recommended to use mild dish soap and
water or a 50/50 solution of water and vinegar.
INTERIOR
Cleaning is easy because little heat is generated to the
interior surfaces; therefore, there is no baking and setting
of spills or spattering. To clean the interior surfaces, wipe
with a soft cloth and warm water. DO NOT USE ABRASIVE
OR HARSH CLEANERS OR SCOURING PADS. For heavier
soil, use baking soda or a mild soap; rinse thoroughly with
hot water. The rack can be cleaned with hot soapy water,
rinsed and dried.
WAVEGUIDE COVER
The waveguide cover is located on the ceiling in the
microwave oven cavity. It is made from mica so requires
special care. Keep the waveguide cover clean to assure
good microwave oven performance. Carefully wipe with
a damp cloth any food spatters from the surface of the
cover immediately after they occur. Built-up splashes may
overheat and cause smoke or possibly catch fire. DO NOT
REMOVE THE WAVEGUIDE COVER.
ODOR REMOVAL
Occasionally, a cooking odor may remain in the microwave
oven. To remove, combine 1 cup water, grated peel and juice
of 1 lemon and several whole cloves in a 2-cup glass measuring
cup. Boil for several minutes using 100% power. Allow to set in
microwave oven until cool. Wipe interior with a soft cloth.
TURNTABLE/TURNTABLE SUPPORT
The turntable and turntable support can be removed for easy
cleaning. Wash them in mild, sudsy water; for stubborn stains
use a mild cleanser and non-abrasive scouring sponge. They
are also dishwasher-proof. Use upper rack of dishwasher. The
turntable motor shaft is not sealed, so excess water or spills
should be wiped up immediately.
GREASE FILTERS
Filters should be cleaned at least once a month. Never operate
the fan or microwave oven without the filters in place.
1. Pull down slightly on the tab toward the front of the
microwave oven and remove the filter. Repeat for the
other filter.
2. Soak the filters in a sink or dish pan filled with hot water
and detergent. DO NOT use ammonia or other alkali;
they will react with the filter material and darken it.
3. Agitate and scrub with a brush to remove embedded
dirt.
4. Rinse thoroughly and shake dry.
5. Replace by fitting the filter back into the opening.
Disconnect the power cord before cleaning or
leave the door open to deactivate the oven during cleaning.
U&C 2.0 bottom control_UL [B321]26 26U&C 2.0 bottom control_UL [B321]26 26 1/31/12 4:00:33 PM1/31/12 4:00:33 PM