Filter
Top Products
10
Be sure doors are set aside in a secure position where
they cannot fall and cause personal injury, or damage
to the doors or handles.
Drawer is heavy. Use caution when lifting.
Once both doors are in place, ensure they are aligned
with each other and level (Please see the “Installation”
section for more details), and replace the top hinge cover.
4 Unscrew the three (3) lower hinge screws and
hinge if necessary.
To reinstall the right door, reverse the above steps.
Open freezer drawer.
2 Remove drawer screws on right and left sides (two
(2) screws on each side).
3 Lift drawer up and out to remove.
With lower slides pulled out, hang drawer onto
slide brackets ensuring pins on each side are fully
inserted into slots on each side.
Tighten four (4) drawer screws.
7 Recheck gasket seal.
8 Installthetoegrillebyttingintoplace.
2 Reinstall four (4) drawer screws (two (2) per side),
tighten down, and close drawer (C).
Pull Drawer Out
From Both Sides
Grab Drawer
At Center
Then
Push Against
Freezer Drawer
A B
Fully Extend
Assembly
Drawer Slides
Pin
Slot
Cabinet
Drawer
Install Screws
(2) Each Side
3 Check gasket seal around top, bottom, and sides of
freezer drawer.
4 If gasket is not sealed, open drawer and slightly
loosen four (4) drawer screws (two (2) on each
side) to allow drawer to rotate.
Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
NOTE
You will be pulling approximately three (3) feet of
water tube from the back of the refrigerator.
NOTE
DO NOT remove center screw from freezer drawer.
This is a factory adjustment.
(on select
models)