Filter
Top Products
31
Visit our web site at
(United States)
(Canada)
-
Ice maker power switch is Off.•
Ice maker has small cube •
caught in mechanism.
Saddle valve on cold water •
pipe is clogged or restricted by
foreign material.
Turn power switch to On (“• I”) position.
Remove small cube from ice maker. The ice and water •
ltercartridgemaybeclogged.Replaceltercartridge.
Turn off household water line valve. Remove valve. En-•
sure that valve is not a self-piercing saddle valve. Clean
valve. Replace valve if necessary.
-
Ice maker is producing less ice •
than you expect.
Check to see if water dispenser •
is dispensing slower than normal.
The ice maker produces approximately 2.5 pounds of ice •
every 24 hours depending on usage conditions.
Ifitis,replacetheiceandwaterltercartridge.•
Ice maker wire signal arm is •
being held down by some item
in the freezer.
Move item and release wire signal arm. Remove any ice •
cubes that are frozen together over the wire signal arm.
Ice cubes are not being used •
frequently enough.
Ice cubes are hollow (partially •
frozen cubes with water inside).
Freezer control is set too warm.•
Remove ice container and discard ice from container. Ice •
maker will produce fresh supply.
Theiceandwaterltercartridgemaybeclogged.Replace•
ltercartridge.
Set freezer control to colder setting. Allow 24 hours for •
temperature to stabilize.
-
Ice storage container is empty.•
Freezer temperature is set too •
warm.
Household water line valve is •
not open.
Ice dispensing arm has been held •
in for more than 4-5 minutes.
Whentherstsupplyoficeisdroppedintothecontainer,•
the dispenser should operate.
Turn freezer control to a higher setting so that ice cubes •
willbemade.Whenrstsupplyoficeismade,dispenser
should operate.
Openhouseholdwaterlinevalve.Allowsufcienttime•
for the ice to be made. When ice is made, the dispenser
should operate.
Motor is overloaded. Motor over load protector will reset in •
approximately 3 minutes. Ice can then be dispensed.
Ice has melted and frozen •
around auger due to infrequent
use,temperatureuctuations,
and/or power outages.
Ice cubes are jammed between •
ice maker and back of ice
container.
Remove ice container, thaw, and empty the contents. •
Clean container, wipe dry, and replace in proper position.
When new ice is made, dispenser should operate.
Remove ice cubes that are jamming the dispenser.•
Door was closed too hard, caus-•
ing other door to open slightly.
Refrigerator is not level. It •
rocksontheoorwhenmoved
slightly.
Refrigerator is touching a wall •
or cabinet.
Close both doors gently.•
Ensureoorislevelandsolid,andcanadequatelysupport•
the refrigerator. Contact a carpenter to correct a sagging
orslopingoor.
Ensureoorislevelandsolid,andcanadequatelysupport•
the refrigerator. Contact a carpenter to correct a sagging
orslopingoor.
Food is touching shelf on top of •
drawer.
Track that drawers slide on is •
dirty.
Remove top layer of items in drawer.•
Ensure drawer is properly installed on track.•
Clean drawer, rollers, and track. See • .