Frigidaire FGHF2344MF Refrigerator User Manual


  Open as PDF
of 41
 
13
NOTE
All set screws should be tightened so the screw is below the surface of the handle. The
handles should be drawn tight to freezer and refrigerator doors with no gaps. Opening the
opposite door while tightening the Allen screw makes installation easier.
The door handle may loosen over time or if it was installed improperly. If this happens,
tighten the set screws on the handles.
INSTALLING DOOR HANDLES
Door Handle Mounting Instructions for Frigidaire Gallery
®
1. Remove handles from carton and any other protective packaging.
2. Position fresh food handle end over upper and lower pre-installed shoulder bolts (A)
that are fastened into door, ensuring the holes for the set screws are facing towards the
opposite door.
3. Whileholdinghandlermlyagainstdoor,fastenupperandlowerAllensetscrews(B)
with supplied Allen wrench.
4. Repeat steps 2 and 3 to install opposite handle. Ensure the holes for the set screws are
facingtowardstherstdoor.
5. Position freezer handle end over left and right pre-installed handle mounts that are
fastened to the door, ensuring the holes for the set screws are facing down.
6. Whileholdinghandlermlyagainstdoor,looselytightenfarrightAllensetscrew(B)withsupplied
Allen wrench until there is no gap between handle and door.
7. Stillholdingthehandlermlytothedoor,rmlytightenfarleftAllensetscrew(B)withsupplied
Allen wrench.
8. ReturntothefarrightAllensetscrew(B)andrmlytightenwithsuppliedAllenwrench.
Mounting Refrigerator Handles
 previous next