GE 164D4290P076 Range User Manual


 
Lift-Off Oven Door
The oven door is removable for easier
access to the light bulb.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Each hinge has a hinge lock. Using
a tool, pull the hinge locks down
against the door frame.
Firmly grasp the door
at the top
sides.
Close the door to the stop position.
Lift the door up and pull straight
out.
To replace the door:
Firmly grasp the door
at the top
sides. This is critical.
Approach the range with the door
angled in a vertical position.
Guide the hinges into the slots.
Push door in firmly while opening.
Once in position, open the door
completely. Push the hinge locks
back in towards the front frame.
To clean the inside of the door:
Because the area inside the gasket is
cleaned during the self-clean cycle, you
do not need to clean this by hand.
The area outside the gasket and the
door liner can be cleaned with a soap-
filled steel wool or plastic pad, hot
water and detergent. Rinse well with a
vinegar and water solution.
To clean the outside of the door:
Use soap and water to thoroughly
clean the top, sides and front of the
oven door. Rinse well. You may also use
a glass cleaner to clean the glass on the
outside of the door. Do not let water
drip into the vent openings.
If any stain on the door vent trim is
persistent, use a soft abrasive cleaner
and a sponge-scrubber for best results.
Spillage of marinades, fruit juices,
tomato sauces and basting materials
containing acids may cause
discoloration and should be wiped up
immediately. When surface is cool,
clean and rinse.
Do not use oven cleaners, cleaning
powders or harsh abrasives on the
outside of the door.
The gasket is designed with a gap
at the bottom to allow for proper air
circulation.
Do not rub or clean the door
gasket—it has an extremely low
resistance to abrasion.
If you notice the gasket becoming
worn, frayed or damaged in any
way or if it has become displaced
on the door, you should have it
replaced.
Pull the hinge locks down to the
unlocked position.
Unlocked
position
Locked position
Control Panel
Clean up splatters with a damp cloth.
You may also use a glass cleaner.
Remove heavier soil with warm
soapy water.
Do not use abrasives of any kind.
Painted Surfaces
Painted surfaces include the sides of the
range and the door, top of control panel
and the drawer front. Clean these with
soap and water or a vinegar and water
solution.
Do not use commercial oven cleaners,
cleaning powders, steel wool or harsh
abrasives on any painted surface.
Safety Instructions
Operating Instructions
Safety Instructions
Operating Instructions
Care and Cleaning Troubleshooting Tips Consumer Support
23
GEAppliances.com